This final adjustment is to correct
for the "designated strike point" on
the zero target.
You are now ready to "fine tune" your
aiming light by firing-in.
CAUTION
Be sure you have removed the
boresight from your weapon
before proceeding.
i
From a supported firing position, turn
on your aiming light and center the
spot on the center of the black
rectangle on the target.
This is
called the "aiming point."
When instructed to "fire," carefully
fire three single rounds at the "aim-
ing point" on the zero target.
When instructed to "check your tar-
get," inspect the shot group and
determine the number of squares
required to adjust the center of your
shot group over the "designated strike
point." The required corrections can
57
