TM 11-5855-217-12
ORGANIZATIONAL MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST
Section i. INTRODUCTION
Code
Explanation
D-1. Scope
supply system and authorized for use at
This appendix lists repair parts and special tools
indicated maintenance categories.
required for the performance of organizational
P2 -Repair parts which are procured and
maintenance of the AN/VSS-3.
the combat or military essentiality of the
D-2. General
end item dictates that a minimum quan-
This repair parts and special tools list is divided
tity be available in the supply system.
into the following sections:
P9 -Assigned to items which are NSA design
a. Prescribed Load Allowance (PLA)-Section
controlled: unique repair parts, special
II. A composite listing of the repair parts, spe-
tools, test, measuring and diagnostic
cial tools, test and support equipment having
equipment, which are stocked and sup-
quantitative allowance for initial stockage at the
plied by the Army COMSEC logistic
organizational level.
system, and which are not subject to the
provisions of AR 380-41.
b. Repair Parts-Section III. A list of repair
P10 -Assigned to items which are NSA design
parts authorized for the performance of mainte-
controlled: special tools, test, measuring
nance of the organizational level.
and diagnostic equipment for COMSEC
c. Special ToolS, Test and Support Equipment-
support, which are accountable under
Section IV. Not applicable.
the provisions of AR 380-41, and which
are stocked and supplied by the Army
d. Federal Stock Number and Reference Num-
COMSEC logistic system.
ber Index-Section V. A list of Federal stock num-
M -Repair parts which are not procured or
bers in ascending numerical sequence followed by
stocked, but are to be manufactured in
a list of reference numbers in ascending alpha-
numeric sequence, cross-referenced to the illus-
tration figure number and item number.
A -Assemblies which are not procured or
stocked as such, but are made up of two
e. Reference Designation Cross-Reference to
or more units. Such component units
Page Number-Section VI. A list of reference
carry individual stock numbers and de-
designations cross-referenced to page number.
scriptions, are procured and stocked
separately and can be assembled to form
D-3. Explanation of Columns
the required assembly at indicated main-
The following provides an explanation of columns
tenance categories.
in the tabular lists:
X -Parts and assemblies which are not pro-
a. Source, Maintenance, and Recoverability
cured or stocked and the mortality of
Codes (SMR), Column 1.
which normally is below that of the ap-
(1) Source codes indicate the selection sta-
plicable end item or component. The
tus and source for the listed item. Source codes
failure of such part or assembly should
are-
result in retirement of the end item from
the supply system.
Explanation
Code
X1 -Repair parts which are not procured or
P
-Repair parts which are stocked in or sup-
stocked. The requirement for such items
plied from the GSA/DSA, or Army